See picture,this is Open-loop to Closed-loop Conversion oscilloscope waveform,my motor startup failure at this moment. I need some advice how to optimize this waveform,Make this electromagnetic Angle ...

I have a problem with running my CLA CODE when I run my program in flash. When i run thise program in RAM, i don't have these problems. Problem description: CLA TASK1 is triggered by int 6.11 (SD1).

I understand from the Sys/Bios download page that ver. 6.83 supports CCSv10.1.0 or higher. Our customer would like to know how to create a Sys/Bios project in CCS ver. 12. Are the training videos in ...

Order of millivolts output swing to be fed into an ADC I'm using currently using TINA-TI to simulate the TIA, with the ultimate goal of producing a tangible physical version of the circuit in the ...

We can't pull a video stream from the camera right now,We want to read the register to confirm the csirx status,Which register should we read? Can you provide a read instruction?

I read the result register for current measurement 1000 times. I found that I got negative value(unit: V), but it shouldn't be like this. here is our pin definition ...

Customer is working on SDK9.1 with SBL boot. They need to use MMCSD_read & MMCSD_write to read / write the EMMC. However, they found that only MMCSD_read could be used, if they use MMCSD_write there ...

as always thanks a lot for your great products and namely the current and voltage sensors line of products. This time we are using the INA219 on our design to measure the 24V input voltage connected ...

To troubleshoot, I tried loading it from U-Boot. When using signed remote core firmware, the authentication verification passed successfully. However, when using ...

Need your help to check below problem. V_CP1 is about 23V. This is for high side current sensing application. CS3_SP4 and CS3_SN4 are connected to a shunt resistor. When there is no current flow into ...

This thread has been locked. If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this ...

I try to make my own flowmeter with EVM430-FR6047 module, but when I connect the EVM430-FR6047 to the Ultrasonic Sensing Device Center (water mode), a message appears: "HID device connected, but could ...