Building a Crabpot - Blue Crab
Here is a list of the individual pieces of wire that you'll need to build your crabpot. Two pieces, each 20 meshes in length, to be used for the main body of the crabpot. One piece, 11 meshes in length, to be used for the parlor. Four pieces, each 2 meshes in length, to be used for the entrance funnels.
Differance between a Crab Trap vs a Crab Pot - Blue Crab Forum
July 17, 2009, 10:39:35 PM. Quote from: CrabShack on July 17, 2009, 09:39:28 PM Here's some pictures that will better explain the difference: 1) Crab Trap 2) Crab Pot. Ron Always looking to learn Always looking to share Always looking for fun. A D V E R T I S E M E N T.
painting crab pots - Blue Crab Forum
2008年2月29日 — Re: painting crab pots. #1. February 29, 2008, 09:02:00 AM. Everybody around here dips them. Make your tank just slightly bigger than the pot, put enough paint in to just come a little over 1/2 way up the pot, turn the pot upside down - dip the top - flip over and dip the bottom - place on tilted drainboard to allow excess to run back into the ...
crab wire cutters - Blue Crab Forum
2017年11月10日 — Re: crab wire cutters. #5. November 12, 2017, 12:26:00 AM Last Edit: November 12, 2017, 10:54:40 AM by Neither Crab. That's what I thought. My main purpose with using vinyl is not having to use zinc 1-2 bars per pot. Another $1.70 each per season plus I feel I caught more crabs in vinyl pots vs. galvonized.
Crab Pot Knots - Blue Crab Forum
2013年3月14日 — Run the line though one hole across the float and though the other hole, knot the end of the of the line and pull it tight to the pipe. Put a knot or 1/2 hitch at the pipe on the long end of the line going to the pot.
Crab Pot Weights?? - Blue Crab Forum
2004年7月21日 — Re:Crab Pot Weights?? #2. July 21, 2004, 07:55:41 AM Last Edit: July 21, 2004, 07:56:37 AM by DocSmith. There's not much current where I crab, so I don't need to use use any weights. Some folks use rebar bent in a square and then attach it to the bottom of the pot on the outside. The crab pot line should be attached in the dead center of the ...
Building a Crabpot - Blue Crab
Step 3.1. Figure 1a. Figure 1b. Figure 1c. Cut a piece of wire 2 meshes long (Figure 1a.) Trim wire so that there are 12 hexagons along the bottom, 10 hexagons along the top. Be sure to leave the three "pigtails" attached to the right-hand side. See Figures 1b and 1c. Discard scraps.
Crab/ crab pot theft - Blue Crab Forum
2004年10月19日 — running pot is lines ie 25 pots with two floats on each side is a better solution. you may loose crabs or the pot from the first one, but rarely do they go down the line. you will also catch more on lines taht in drop pots (one pot per float) but it takes a little longer to fish pots in lines. www.mediacourtdiner.com.
Help! Non-commercial Crab pot license, and "agents" pulling pots.
2009年5月28日 — Non-commercial Crab pot license, and "agents" pulling pots. Ok, here is the official answer from marine code enforcement. You CAN NOT tend anyone elses pots for any reason. No special permissions will be given. When asked about the "agent" wording, they said that it pertained to commercial crabbing.
crab pot dip
2020年2月28日 — What you should do is make a power washer wand with 3-4 nozzles stacked vertically, aimed off the side of the boat. Then build a rotating stand for the pot to set on. Pull the pot, shake it, slide it down the washboard in front of the nozzles, spin it and back over.